Features of hot stamping machine products:
1. Electronic digital thermostat controls temperature with high accuracy (plus or minus 2 ℃)
2. Precision wrapped tube cast aluminum plate, with heating wire and heating plate integrated, uniform thermal distribution, safe and durable:
3. The heating plate contains anti sticking high-temperature cloth
4. Electronic time control, process completion signal indication
5. Pressure can be adjusted at any time
6. The bottom plate is equipped with high-temperature resistant foam silicone, which can withstand temperatures up to 350 ℃
Operation process of hot stamping machine:
1. Hand plug the power supply, turn on the power switch, and the power indicator light will immediately turn on
2. Adjust the temperature regulator to the required temperature. When the temperature reaches the set temperature, the indication on the upper part of the temperature regulator will be off, and then work can start.
3. Adjust the time controller to the desired time.
4. Place the transfer hat on the lower ironing board, then put on the ironing paper (pay attention to the front and back of the ironing paper), and press the handle down firmly until the end point
Attention: Do not apply more than 30 kilograms of force, otherwise it may cause deformation of the handle.
5. When the time controller for hot stamping is set, the buzzer will sound, indicating that the handle will be lifted up to its original position.
6. If it is cold torn hot paper, please use a blackboard eraser to evenly rub the hot paper once, wait for 5 to 10 seconds, and then tear off the hot paper.
The above is an introduction to the characteristics of hot stamping machines, hoping that everyone can gain some insights.
Cowint is the largest DTF Film Factory in China
