Corporate cultu

Product overview

Technical index		Scope of application	Features
Exterior	Milky white paste	It is suitable for printing on all kinds of needles, woven cotton cloth, T/C cloth, cotton pull frame and modal.	① Good washing fastness, soft, dry, and good operability. ② After SGS testing, the four items including formaldehyde, APEO, PVC/phthalate, and heavy metals all meet EU requirements.
pH value	7-8
Ionicity	Anion

Instructions for use

Recommended formula		Printing conditions		Printing process
Transparent	20-80％	Schaber	Water-based spatula 65 degrees	Printing → natural drying → through the drying tunnel (130°C-150°C, 1-3 minutes) or pressing (150°C, 10S) → finished product
White paste	80-20％	Netzgarn	1200 mesh
Color	x	overheat	130°C-150°C，1-3min
		Number of knives	Up and down, twice

Remarks:

① The amount of color cannot exceed the normal standard;

② Make sure that the printing is completely dry when testing, otherwise the test results will be affected;

③ To achieve the best effect of this product without heat treatment, it is recommended to add a fixing aid or extend the natural air drying time appropriately.

Finished product performance

Test items	Performance	Detection method
Softness	3-4	Internal standard (level 5: very soft; level 4: soft; level 3: moderate; level 2: hard; level 1: very hard)
elasticity	3	Internal standards (level 5: high elasticity; level 4: good elasticity; level 3: moderate; level 2: elastic deviation; level 1: no elasticity)
Color fastness to dry rubbing	Level 3-4	GB/T 3920-2008, 10 cycles of friction
Color fastness to wet rubbing	Level 3-4	GB/T 3920-2008, 10 cycles of friction
Dryness	3-4	Internal standards (level 5: very dry; level 4: dry; level 3: moderate; level 2: slightly sticky; level 1: sticky hands)
Machine wash fastness	pass	60°C water temperature, 5g washing powder, standard washing for 2.5 hours, washing and drying cycles of 5 times.

Remarks:

① Test piece cloth type: cotton cloth;

② Test piece printing formula: 76.5% transparent paste + 16.5% white paste + 7% color;

③ The printing process of the test piece: water-based scraper 65 degrees, 1200 mesh net yarn, upper and lower cut twice, 130°C overheating 70S.

Matters Needing Attention

Operation matters	Storage conditions	Emergency measures
Take safety precautions during the printing process; please recycle and dispose of the waste slurry instead of discarding it randomly.	Store in a cool and ventilated warehouse; keep away from heat and direct sunlight; keep the container tightly closed	After contact with skin and eyes, please wash with plenty of water. If you feel unwell, please consult a doctor; if inhaled or swallowed, please consult a doctor.

5.Company culture construction

202103060024339682902