Tips For Water-based Silicone Printing

Aug 04, 2022 Leave a message

The amount of sizing will directly affect the effect of the print.The higher the sizing amount, the brighter the surface of the print, but the more water-based silica gel attached to the fabric it will affect the feel of the fabric.

The amount of sizing will directly affect the effect of the print.The more the sizing amount, the brighter the surface of the print, but the more water-based silica gel attached to the fabric it will affect the feel of the fabric and increase the cost.So, under the condition of ensuring brightness, Reduce sizing. After the proof test, it is appropriate to increase the gram value of the fabric after printing by 30-50g/m2. The weight of the printed fabrics is closely related to the following factors: viscosity of aqueous silica gel, mesh number of cylinder and coating thickness of photosensitive adhesive, diameter of magnetic rod and magnitude of magnetic force , and vehicle speed. In general, the greater the viscosity of the water-based silica gel slurry, the greater the degree of sizing and weight gain, the thicker the magnetic bar, is the less the magnetic field and the more slurry is collected on the fabric; the lower the mesh count, the more luminous the glue The thicker the coating, the more fat deposited on the fabric, and the higher the gram value, the slower the speed , the more penetrating the oil. Therefore, in order to obtain good print quality, the above factors must be properly controlled.