1.Nitrocellulose and epoxy resin should be avoided for copper-gold powder. Because both will chemically react with copper to form a jelly; if these two resins must be used, they should be used in a short time as much as possible.
2. Since acidity will oxidize and blacken the copper and gold powder, resins with a low acid value (less than 3) should be used as much as possible. The lower the acid value of the resin system, the better.
3. Aromatic hydrocarbons and ester solvents help to completely wet the copper and gold powder particles to achieve full dispersion. Avoid using alcohol and ketone solvents and incompletely acidified lipid solvents.
4. Copper-gold powder is easily oxidized when exposed to water, so be sure to use high-purity resins and solvents (low water content). If there is a small amount of water, it is recommended to use molecular sieve silosievea4 or aerosilr972 to remove water before adding gold powder pigments.






















